imdaring
love my reef
Just go a new PH meter and I'm calibrating it and in theeinstructions it says
1) immerse the electrode in PH 6.8 buffer solution
2) allow to stabilize and with the small screw driver turn the calibration trimmer until the display shows is corresponding the solution
THAT PART IS DONE AND OK NOW
3) immerse the electrode in pH4.01 standard buffing solution
4) after one minute, until the buffer solution value is corresponding the measurement temperature is obtained
??????? do I use the srew driver again to calibrate it?? because it reads 4.60 and the bottle shows 4.01?
1) immerse the electrode in PH 6.8 buffer solution
2) allow to stabilize and with the small screw driver turn the calibration trimmer until the display shows is corresponding the solution
THAT PART IS DONE AND OK NOW
3) immerse the electrode in pH4.01 standard buffing solution
4) after one minute, until the buffer solution value is corresponding the measurement temperature is obtained
??????? do I use the srew driver again to calibrate it?? because it reads 4.60 and the bottle shows 4.01?